Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Starting from middle of G-Code
03-31-2013, 04:36 PM
Post: #1
Starting from middle of G-Code
I have had a lot of problems recently with the printer freezing on the new PC I installed it on. Mainly issues with my PC. But it would be really cool if you could enter a line number for the printer to start on the G-Code so it can finish where it left off. Then one could take the last code output to it and run from there.
Find all posts by this user
Quote this message in a reply
04-01-2013, 03:36 PM
Post: #2
RE: Starting from middle of G-Code
(03-31-2013 04:36 PM)tlrocketman Wrote:  I have had a lot of problems recently with the printer freezing on the new PC I installed it on. Mainly issues with my PC. But it would be really cool if you could enter a line number for the printer to start on the G-Code so it can finish where it left off. Then one could take the last code output to it and run from there.

Yes, that would be very valuable. Wouldn't be easy... if we create our own Pronterface equivalent we might tackle that.
Find all posts by this user
Quote this message in a reply
04-02-2013, 09:27 PM
Post: #3
RE: Starting from middle of G-Code
Oh, I didnt know if there was a way to make a simple G code editor to trick it into thinking that was the beginning.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)