PolyPrinter Forums / Printables / Post Your Prints / ERAU Formula Hybrid SAE BMS enclosure

Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ERAU Formula Hybrid SAE BMS enclosure
03-27-2013, 05:54 PM (This post was last modified: 04-01-2013 11:54 AM by tlrocketman.)
Post: #1
tlrocketman Offline
Junior Member
**
 		Posts: 14
Joined: Feb 2013
Reputation: 0
ERAU Formula Hybrid SAE BMS enclosure
Battery Monitoring System (BMS) for High Voltage system. The existing box had poor connectors, was made out of steel which was really heavy as well as conductive. Soldered in some new connectors and printed this gem around it.

The standoffs for the board came out quite nice as well. I made the hole the minor pitch diameter so the screw would self tap it.


Attached File(s) Image(s)
               
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | PolyPrinter | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication