Post Reply 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
extruder / pronterface issue
08-19-2013, 10:22 AM
Post: #1
extruder / pronterface issue
Hello all,
I've sent this James and Ed, so I'm sure a solution is near:

I got this error message on pronterface last night.

Printer is now online.
Saving failed for set last_file_path: [Errno 13] Permission denied: 'C:\\Users\\Jess\\printrunconf.ini~bak'

and this:

Saving failed for set port: [Errno 13] Permission denied: 'C:\\Users\\Jess\\printrunconf.ini~bak'

However my print job seemed to work fine.

This morning, I got the same error message,even after I rebooted the computer.
Now there seems to be a problem with the extruder. For lack of a better word, the extruder is 'spitting' out plastic.

Here's the link to the vids:

Any ideas?
Quote this message in a reply
Post Reply 

Messages In This Thread
extruder / pronterface issue - jess1234 - 08-19-2013 10:22 AM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)